118
Zone 2—Continued
This section explains how to turn Zone 2 on and off, how
to select an input source for Zone 2, and how to adjust
the volume for Zone 2.
Controlling Zone 2 from the AV receiver
Note:
While Powered Zone 2 is being used, listening modes
that require surround back speakers (6.1/7.1), such as
Dolby Digital EX, DTS-ES, and THX Ultra2 Cinema,
are unavailable.
Controlling Zone 2 with the Remote
Controller
Note:
To control Zone 2, you must press the remote control-
ler’s [Zone 2] button first.
Using Zone 2
1
To turn on Zone 2 and select an
input source, press the [Zone 2]
button repeatedly.
Alternatively, press the [Zone 2]
button followed by an input
selector button within 8 seconds.
Zone 2 turns on, the Zone 2 indicator
lights up.
To select AM or FM press the [Tuner]
input selector button repeatedly. On the
North American model, you can also
select XM or SIRIUS.
To select the same source as that of the
main room, press the [Zone 2] button
repeatedly until “Z2 Selector: Source”
appears on the display.
Note:
You cannot select different AM or FM
radio stations for your main room and
Zone 2. The same AM/FM radio station
will be heard in each room.
2
To turn off Zone 2, press the [Off]
button.
1
1
2
1
Press the [Zone 2] button, then
point the remote controller at the
AV receiver and press the [On/
Standby] button.
Zone 2 turns on, the Zone 2 indicator
lights up.
2
To select an input source for
Zone 2, press the [Zone 2] but-
ton, followed by an Input Selector
button.
To select AM or FM press the [Tuner]
Input Selector button repeatedly. On the
North American model, you can also
select XM or SIRIUS.
Note:
You cannot select different AM or FM
radio stations for your main room and
Zone 2. The same AM/FM radio station
will be heard in each room.
3
To turn off Zone 2, press the
[Zone 2] button, followed by the
[On/Standby] button.
Input
Selector
On/Standby
Zone2
To Next Page
Loading...
