60
Listening to the Radio—Continued
Setting the Satellite Radio Mode
Before you can listen to XM Satellite Radio, you must
set the SAT Radio Mode to “XM”.
Selecting XM Satellite Radio
1
Press the [Receiver] button, fol-
lowed by the [Setup] button.
The main menu appears onscreen.
2
Use the Up and Down [q]/[w] but-
tons to select “7. Hardware
Setup”, and then press [Enter].
The “Hardware Setup” menu appears.
3
Use the Up and Down [q]/[w] but-
tons to select “3. Tuner”, and
then press [Enter].
The “Tuner” screen appears.
Receiver
Enter
Setup
7. Hardware Setup
1. Remote Control
2. Zone2
3. Tuner
4. Analog Multich
5. HDMI
6. Network
7–3. Tuner
SAT Radio Mode
Antenna Aiming
SURIUS Parental Lock
XM
4
Use the Left and Right [e]/[r]
buttons to select “XM”.
If there are 2 items on the Tuner
screen, use Up and Down [q]/[w]
buttons to select “SAT Radio
Mode”.
Pressing the Left and Right [e]/[r]
buttons cycles through the following
options: None → XM → SIRIUS →
XM/SIRIUS
None: Select if you’re not using Sat-
ellite Radio.
XM: Select to use XM Satellite
Radio.
SIRIUS: Select to use SIRIUS Satellite
Radio.
XM/SIRIUS:
Select to use XM Satellite
Radio and SIRIUS Satellite
Radio.
5
When you’ve finished, press the
[Setup] button.
The setup menu closes.
AV receiver
On the AV receiver, press the
[Tuner] button repeatedly to
select “XM”.
Remote
controller
On the remote controller, press
the [Tuner] button repeatedly to
select “XM”.
If “CHECK XM TUNER” appears on
the display, make sure the XM Mini-
Tuner is connected properly.
Tuner Setup
Enter
Tuning
To Next Page
Loading...
