Using the Setup Program
40
Hard Drive Submenu
Use this submenu to configure the boot sequence for hard drives.
Table 17. Hard Drive Submenu
Options Description
• Installed hard drive
• Bootable ISA Cards
Specifies the boot sequence for the hard drives attached to the computer. To
specify boot sequence:
1. Select the boot device with <↑> or <↓>.
2. Press <+> to move the device up the list or <-> to move the device down
the list.
The operating system assigns a drive letter to each device in the order listed.
Changing the order of the devices changes the drive lettering.
Removable Devices Submenu
Use this submenu to configure the boot sequence for removable devices.
Table 18. Removable Devices Submenu
Options Description
• Legacy Floppy Drives
Specifies the boot sequence for the removable hard drives attached to the
computer. To specify boot sequence:
1. Select the boot device with <↑> or <↓>.
2. Press <+> to move the device up the list or <-> to move the device down
the list.
The operating system assigns a drive letter to each device in the order listed.
Changing the order of the devices changes the drive lettering.
Exit Menu
Use this menu to exit the Setup program, save changes, load defaults, and save defaults.
Table 19. Exit Menu
Feature Description
Exit Saving Changes Exits and saves the changes in CMOS RAM.
Exit Discarding Changes Exits without saving any changes made in Setup.
Load Setup Defaults Loads the default values for all the Setup options.
Load Custom Defaults Loads the custom defaults for Setup options.
Save Custom Defaults Saves the current values as custom defaults. Normally, the BIOS reads the
Setup values from flash memory. If this memory is corrupted, the BIOS reads
the custom defaults. If no custom defaults are set, the BIOS reads the factory
defaults.
Discard Changes Discards changes without exiting Setup. The option values present when the
computer was turned on are used.
To Next Page
Loading...
Need help?
General
