Intel Atom N2800 User Manual


125
6. Write the image to the USB stick by selecting Write.
7. Insert the USB stick into the CRB.
8. When you boot the BIOS be sure to select the USB stick as the primary boot drive.
9. When the Boot: prompt appears, you must type install to install to the attached
SATA drive.
a. Note this prompt only remains on the screen for a few seconds, so you need to
be prepared for it.
10. You will be asked to confirm the drive you intend to install the Yocto Project*
bits 
Note: The Yocto Project* install will assume the entre drive will be used for Project.
Dual boot options, discovery of existing partitions and OSs are not enabled.
7.6.4 Install with CD or DVD
Currently, installing Yocto Project* via CD or DVD is not enabled.
7.6.5 Graphics Driver
The preliminary Yocto Project* BSP graphics driver will be based on the standard Linux
VESA driver. This VESA driver will not be able to take advanta
engine. Closed source hardware accelerated graphics drivers will be incorporated into
future releases of the Yocto Project BSP.

Intel Atom N2800 Specifications

General

Processor Number	N2800
Number of Cores	2
Number of Threads	4
Base Frequency	1.86 GHz
TDP	6.5 W
Instruction Set	64-bit
Lithography	32 nm
Launch Date	Q1'12
Instruction Set Extensions	SSE2, SSE3, SSSE3
Embedded Options Available	Yes
Max Memory Size	4 GB
Number of Memory Channels	1
Processor Graphics	Intel® Graphics Media Accelerator 3650
Graphics Base Frequency	640 MHz
Graphics Max Dynamic Frequency	640 MHz
Sockets Supported	BGA559
Max CPU Configuration	1
Idle States	Yes
Intel® 64	Yes
Intel® Identity Protection Technology	No
PCI Express Revision	2.0
Cache	1 MB
Memory Types	DDR3 800
PCI Express Configurations	1x4