Installing and Replacing Desktop Board Components
45
Loading the SATA RAID or SATA Driver
Follow the steps below if the SATA drive is the primary drive in the system:
a) With Microsoft Windows
†
2000 and Windows XP, do the following:
1. As Windows Setup begins, press <F6> to specify the SATA RAID or SATA driver.
2. Press <S> to specify an additional device.
3. Insert the floppy disk labeled SATA drivers and press <Enter>.
4. If RAID has been configured in BIOS, press <Enter> to select the Silicon Image Serial
ATA RAID Controller; if not, press <Enter> to select the Silicon Image SiI 3112 Serial
ATA Controller.
5. Press <Enter> to continue Windows Setup.
b) With Microsoft Windows 98 SE and Windows Me, do the following:
1. Perform full installation of Windows 98 SE or Windows Me.
2. Install the SATA RAID driver or SATA driver from the Intel Express Installer CD-ROM.
✏
NOTE
If the SATA drive in the system is configured as a secondary drive, the SATA and SATA RAID
drivers do not need to be installed prior to loading the operating system. After loading the
operating system on the primary drive in the system, the SATA RAID or SATA driver can be
installed from the Intel Express Installer CD-ROM.
To Next Page
Loading...
Need help?
General
