CW250, Users
Rev M, April 2018
Page 17 of 31
2. When the first group of items to be weighed is stable on the scales, press the
PRINT/ACCUMULATE button. If using a printer, a print ticket with all weights will be
printed. The display will return to the setting the accumulation was obtained from.
The weight from the first group will become the accumulated total. The
accumulated total can be displayed by pressing the LOCAL/TOTAL button when
the TOTAL icon is flashing. An accumulation cannot be made in standard mode if
the scale is in the Accumulation Print mode with the TOTAL icon flashing. When
the accumulation is complete, remove the first group of items from the scale(s).
3. When the next group of items to be weighed is stable on the scale(s), press the
PRINT/ACCUMULATE button. The total weight will be added to the accumulated
total. If using a printer, a print ticket with all weights will be printed.
4. Repeat step 3 as required for additional weigh groups. If the accumulated total
becomes too large to display, the message "" and an error icon will be
displayed.
5. When finished, the accumulated total weight can be cleared by pressing and
holding the ZERO button until the display shows ".".The display will clear the
accumulated total and the number of accumulations.
ACCUMULATE NOTE: The scale will not accumulate when the weight is negative,
zero, or if the weight is in motion. The protections are added to ensure only valid
readings are accumulated into the total. An error message "." will be
displayed when any of the three conditions are present. At the completion of a
successful accumulation, the scale must be returned to zero before the next weight
accumulation can be initiated. If an attempt is made to accumulate the next weight
before allowing the scale to return to zero, the error message ".” will be
displayed.
To Next Page
Loading...
