CW250, Users
Rev M, April 2018
Page 29 of 31
Diagnostic Codes
Step Choice Codes
Step Choice codes are used in some calibration procedures and can also be used to
aid in troubleshooting scale performance problems. The codes are typically used by
scale technicians. Common Step Choice diagnostic codes are presented in the table
below.
Advance to the first Calibration Menu step.
Advance directly to weight calibration.
Accesses the Mode Menu, just as if the cal strap had been left in the
RUN position.
Raw counts display diagnostic
Constant power to all cells diagnostic
Restore all radio settings to defaults (CH = 1, Network ID = 8000,
Encryption = 8000. Display will show "save" if successful, or ""
if there is a radio failure or if no radio installed.
Restore all settings to defaults, but leave the weight calibration
settings intact.
Restore all settings to default settings, including weight calibration.
The "" code should only be used when all other attempts at
troubleshooting have been exhausted as all calibration and other
settings will be deleted.
To Next Page
Loading...
