80 Contents Index AdvisorOne User Manual 1.9.x 466-4421 • REV A • ISS 14APR2016 ©2016 United Technologies Corporation
Avoid the motion sensor field of view for 5 minutes, and then enter its
view.
Press and hold the test button until the system sounds transmission
beeps.
Note: More / additional bars represent stronger signal strength. All sensors should
have at least two bars. If any reading seems low or incorrect, contact the service
provider for more information.
5. When all sensors have been tripped, check the panel screen for a sensor with a
green circle. This indicates that the sensor was not tripped or the AdvisorOne panel
did not receive a signal from it. Retest that sensor.
6. Press CLOSE to exit.
7. If the central monitoring station was notified, inform them that this operation is
complete.
To Next Page
Loading...
