Interlogix NS3552-8P-2S-V2 - Page 170

Chapter 4: Web configuration
168 NS3552-8P-2S-V2 User Manual
The page includes the following fields:
Object Description
VLAN ID VLAN ID of the group.
Group Group address of the group shown.
Port Switch port number.
Mode Indicates the filtering mode maintained per basis (VLAN ID, port number,
Group Address). It can be either Include or Exclude.
Source Address IP Address of the source. Currently, the system limits the total number of IP
source addresses for filtering to 128.
Type Indicates the type. It can be either Allow or Deny.
Hardware
Filter/Switch
Indicates if the data plane destined to the specific group address from the
source IPv4 address can be accomodated by the chip.
Buttons
• Select Auto-refresh to automatically refresh the page every three seconds.
• Click Refresh to refresh the table starting from the input fields.
• Click I<< to update the table starting from the first entry in the MLD SFM information
table.
• Click >> to update the table, starting with the entry after the last entry currently
shown.
MVR (Multicast VLAN Registration)
The MVR feature enables multicast traffic forwarding on the Multicast VLANs.
• In a multicast television application, a computer or a network television or a set-top
box can receive a multicast stream.
• Multiple set-top boxes or computers can be connected to one subscriber port, which
is a switch port configured as an MVR receiver port. When a subscriber selects a
channel, the set-top box or computer sends an IGMP/MLD report message to
Switch A to join the appropriate multicast group address.
• Uplink ports that send and receive multicast data to and from the multicast VLAN
are called MVR source ports.
A maximum of eight MVR VLANs with corresponding channel settings can be created
for each multicast VLAN. A maximum of 256 group addresses are available for channel
settings.