Interlogix NS3552-8P-2S-V2 - Port Management Command

Chapter 6: Command line mode
334 NS3552-8P-2S-V2 User Manual
Port Management Command
Port Configuration
Description:
Show port configuration.
Syntax:
Port Configuration [<port_list>] [up|down]
Parameters:
<port_list>: Port list or 'all', default: All ports
up : Show ports, which are up
down : Show ports, which are down
(default: Show all ports)
Example:
Display port1~4 status
NS3552
-8P-2S-V2:/>
port configuration 1-4
Port
Configuration:
===================
Port State Mode Flow Control MaxFrame Power Excessive
Link
----
-------- ------ ------------ -------- -------- --------- ----
1 Enabled Auto Disabled 9600 Disabled Discard Do
wn
2 Enabled Auto Disabled 9600 Disabled Discard Down
3 Enabled Auto Disabled 9600 Disabled Discard Down
4 Enabled Auto Disabled 9600 Disabled Discard Down
Port Mode
Description:
Set or show the port speed and duplex mode.
Syntax:
Port Mode [<port_list>] [auto|10hdx|10fdx|100hdx|100fdx|1000fdx]
Parameters:
<port_list>: Port list or 'all', default: All ports
auto : Auto negotiation of speed and duplex
10hdx : 10 Mbps, half duplex
10fdx : 10 Mbps, full duplex
100hdx : 100 Mbps, half duplex
100fdx : 100 Mbps, full duplex
1000fdx : 1 Gbps, full duplex
(default: Show configured and current mode)
Default Setting:
Auto
Example: