Interlogix NS3552-8P-2S-V2 User Manual

Chapter 6: Command line mode
NS3552-8P-2S-V2 User Manual 425
Ethernet Protection Switching Command
EPS Create
Description:
EPS create.
Syntax:
EPS create [<inst>] [domport|dompath|domservice|dommpls] [1p1|1f1] [<flow_w>]
[<flow_p>] [<mep_w>] [<mep_p>][<mep_aps>] [enable|disable]
Parameters:
<inst> : Instance number
domport|dompath|domservice|dommpls: Flow domain
1p1|1f1 : EPS architecture
<flow_w> : Working flow instance number
<flow_p> : Protecting flow instance number
<mep_w> : Working MEP instance number
<mep_p> : Protecting MEP instance number
<mep_aps> : APS MEP instance number
enable|disable : enable/disable protection
EPS Config
Description:
EPS config operation.
Syntax:
EPS config [<inst>] [aps|noaps] [revert|norevert] [unidir|bidir]
[w0s|w10s|w30s|w1m|w5m|w12m][h0s|h100ms|h500ms|h1s|h2s|h5s|h10s]
Parameters:
<inst> : Instance number
aps|noaps : APS enable/disable
revert|norevert : Revertive enable/disable
unidir|bidir : Unidirectional or bidirectional switching
w0s|w10s|w30s|w1m|w5m|w12m : Wait to restore timer value
h0s|h100ms|h500ms|h1s|h2s|h5s|h10s: Hold off timer value
EPS Command
Description:
EPS command set operation.
Syntax:
EPS command [<inst>]
[clear|lockout|forced|manualp|manualw|exercise|freeze|lockoutlocal]
Parameters:
<inst> : Instance number
clear|lockout|forced|manualp|manualw|exercise|freeze|lockoutlocal: EPS protection
command type - clear is 'no command active'
EPS State
Description:

Interlogix NS3552-8P-2S-V2 Specifications

General

Brand	Interlogix
Model	NS3552-8P-2S-V2
Category	Switch
Language	English