Interlogix NS3552-8P-2S-V2 - Page 236

Chapter 4: Web configuration
234 NS3552-8P-2S-V2 User Manual
ons
sions
RADIUS authentication
server.
Tx Pending
Requests
radiusAuthClientEx
tPendingRequests
The number of RADIUS
Access-Request packets
destined for the server that
have not yet timed out or
received a response. This
variable is incremented
when an Access-Request
is sent and decremented
due to receipt of an
Access-Accept, Access-
Reject, Access-Challenge,
timeout, or retransmission.
Tx Timeouts radiusAuthClientEx
tTimeouts
The number of
authentication timeouts to
the server. After a timeout,
the client may retry to the
same server, send to a
different server, or give up.
A retry to the same server
is counted as a retransmit
as well as a timeout. A
send to a different server is
counted as a Request as
well as a timeout.
Other Info This section contains information about the state of the server and the latest
round-trip time.
Name RFC4668
Name
Description
IP Address
- IP address and UDP port for the authentication
server in question.
State
- Shows the state of the server. It takes one of
the following values:
Disabled: The selected server is disabled.
Not Ready: The server is enabled, but IP
communication is not yet up and running.
Ready: The server is enabled, IP
communication is up and running, and the
RADIUS module is ready to accept access
attempts.
Dead (X seconds left): Access attempts were
made to this server, but it did not reply within
the configured timeout. The server has
temporarily been disabled, but will get re-
enabled when the dead-time expires. The
number of seconds left before this occurs is
displayed in parentheses. This state is only
reachable when more than one server is
enabled.
Round-Trip
Time
radiusAuthClie
ntExtRoundTrip
Time
The time interval (measured in milliseconds)
between the most recent Access-Reply/Access-
Challenge and the Access-Request that
matched it from the RADIUS authentication