Chapter 4: Web configuration
NS3552-8P-2S-V2 User Manual 241
Please note that if you want to change the 802.1x authentication type of a wireless
client, (i.e., switch to EAP-TLS from EAP-MD5), you must remove the current existing
wireless network from your preferred connection first, and add it in again.
Configuration sample: EAP-MD5 authentication
1. Go to Start > Control Panel, and then double-click on Network Connections.
2. Right-click on the Local Network Connection.
3. Click Properties to open up the Properties setting window.
4. Click the Authentication tab.
5. Select Enable network access control using IEEE 802.1X to enable 802.1x
authentication.
6. Select MD-5 Challenge from the drop-down list box for EAP type.
To Next Page
