Interlogix NS3552-8P-2S-V2 - Page 418

Chapter 6: Command line mode
416 NS3552-8P-2S-V2 User Manual
voice : Voice for use by dedicated IP Telephony handsets and other
similar appliances supporting interactive voice services. These
devices are typically deployed on a separate VLAN for ease of
deployment and enhanced security by isolation from data
applications
voice_signaling : Voice Signaling (conditional) for use in network topologies
that require a different policy for the voice signaling than for the
voice media.
guest_voice : Guest Voice to support a separate limited feature-set voice
service for guest users and visitors with their own IP Telephony
handsets and other similar appliances supporting interactive
voice services.
guest_voice_signaling : Guest Voice Signaling (conditional) for use in network
topologies that require a different policy for the guest voice
signaling than for the guest voice media.
softphone_voice : Softphone Voice for use by softphone applications on
typical data centric devices, such as PCs or laptops. This class
of endpoints frequently does not support multiple VLANs, if at
all,and are typically configured to use an untagged VLAN or a
single tagged data specific VLAN.
video_conferencing : Video Conferencing for use by dedicated Video
Conferencing equipment and other similar appliances
supporting real-time interactive video/audio services.
streaming_video : Streaming Video for use by broadcast or multicast based
video content distribution and other similar applications
supporting streaming video services that require specific
network policy treatment. Video applications relying on TCP
with buffering would not be an intended use of this application
type.
video_signaling : Video Signaling (conditional) for use in network topologies
that require a separate policy for the video signaling than for
the video media.
tagged : The device is using tagged frames
unragged : The device is using untagged frames
<vlan_id> : VLAN id
<l2_priority>: This field may specify one of eight priority levels (0 through 7), as
defined by IEEE 802.1D-2004 [3].
<dscp> : This field shall contain the DSCP value to be used to provide Diffserv
node behavior for the specified application type as defined in IETF
RFC 2474 [5]. This 6 bit field may contain one of 64 code point values
(0 through 63). A value of 0 represents use of the default DSCP value
as defined in RFC 2475.
LLDP MED Port Policy
Description:
Set or show LLDP-MED port polcies.
Syntax:
LLDPMED port policies [<port_list>] [<policy_list>]
Parameters:
<port_list> : Port list or 'all', default: All ports