Interlogix NS3552-8P-2S-V2 - Page 447

Chapter 6: Command line mode
NS3552-8P-2S-V2 User Manual 445
<dport> : Dest. TCP/UDP port:(0-65535) or 'any', specific or port range
ipv6 : IPv6 keyowrd
<sip_v6> : IPv6 source address: (a.b.c.d/n) or 'any', 32 LS bits
<class> : QoS Class: "class (0-7)", default: basic classification
<dp> : DP Level: "dp (0-1)", default: basic classification
<classified_dscp>: DSCP: "dscp (0-63, BE, CS1-CS7, EF or AF11-AF43)"
QoS QCL Delete
Description:
Delete QCE entry from QoS Control list.
Syntax:
QoS QCL Delete <qce_id>
Parameters:
<qce_id>: QCE ID (1-256), default: Next available ID
Default Setting:
disable
Example:
Enable multicast storm control in 2fps
NS3552
-8P-2S-V2:/> QoS Storm multicast enable 2
QoS QCL Lookup
Description:
Lookup QoS Control List.
Syntax:
QoS QCL Lookup [<qce_id>]
Parameters:
<qce_id>: QCE ID (1-256), default: Next available ID
Default Setting:
disable
Example:
Enable multicast storm control in 2fps
NS3552
-8P-2S-V2:/>
QoS Storm multicast enable 2
QoS QCL Status
Description:
Show QCL status. This can be used to display if there is any conflict in QCE for
differnet user types.
Syntax:
QoS QCL status [combined|static|voice_vlan|conflicts]
Parameters:
combined|static|voice_vlan|conflicts: combined : Shows the combined
status
static : Shows the static user configured status
voice_vlan : Shows the status by Voice VLAN
conflicts : Shows all conflict status
(default : Shows the combined status)