Interlogix NS3552-8P-2S-V2 - Page 462

Chapter 6: Command line mode
460 NS3552-8P-2S-V2 User Manual
ERPS MEP
Description:
Associating Port 0/1 MEP to a protection group
<east_sf_mep> : Mep_ID for finding out Continuity Check errors on Port 0
<west_sf_mep> : Mep_ID for finding out Continuity Check errors on Port 1
<east_raps_mep> : Mep_ID for transmitting R-APS frames on Port 0
<west_raps_mep> : Mep_ID for transmitting R-APS frames on Port 1
<group_id> : protection group id for which mep is associating.
Syntax:
Erps mep <east_sf_mep> <west_sf_mep> <east_raps_mep> <west_raps_mep>
<group-id>
Parameters:
<east_sf_mep> : SF mep id for Port 0
<west_sf_mep> : SF mep id for Port 1
<east_raps_mep>: CC/RAPS mep id for Port 0
<west_raps_mep>: CC/RAPS mep id for Port 1
<group-id> : protection group id 1 - 64
ERPS RPL Neighbour
Description:
Selection of RPL neighbour for a protection group
(east|west) : selected east(Port 0) or west(Port 1) as RPL neighbour
<group-id> : protection group id for selecting RPL Block.
Syntax:
Erps rpl neighbour <rpl_port> <group-id>
Parameters:
<rpl_port>: RPL Block
<group-id>: protection group id 1 - 64
ERPS RPL Owner
Description:
Selection of RPL Block for a protection group
by default this node is considered as RPL Owner
(east|west) : select east(Port 0) or west(Port 1) as RPL Block
<group-id> : protection group id for selecting RPL Block.
Syntax:
Erps rpl owner <rpl_port> <group-id>
Parameters:
<rpl_port>: RPL Block
<group-id>: protection group id 1 - 64
ERPS RPL Neighbour Clear
Description:
make this node as non-neighbour for a protection group
<group-id> : protection group id for selecting RPL Block.
Syntax:
Erps rpl neighbour clear <group-id>
Parameters: