Interlogix NS3552-8P-2S-V2 - Page 98

Chapter 4: Web configuration
96 NS3552-8P-2S-V2 User Manual
The page includes the following fields:
Object Description
Type Displays the type of current SFP module. The possible types are:
• 1000Base-SX
• 1000Base-LX
• 100Base-FX
Speed Displays the speed of the current SFP module. Different vendors’
SFP modules might show different speed information.
Wave Length(nm) Displays the wavelength of current SFP module. Use this column to
check if the wavelength values of two nodes are matched when the
fiber connection fails.
Distance(m) Displays the supported distance of the current SFP module.
Temperature(C) Displays the temperature of the current SFP module.
Voltage(V) Displays the voltage of the current SFP module.
Current(mA) Displays the Ampere of the current SFP module.
TX power(dBm) Displays the TX power of the current SFP module.
RX power(dBm) Displays the RX power of the current SFP module.
Buttons
• Select the SFP Monitor Event Alert check box. The switch will be in accordance
with the Warning Temperature setting and allows users to record message out via
SNMP Trap.
• Click Save to save changes.
• Click Reset to undo any changes made locally and revert to previously saved
values.
• Click Refresh to refresh the page immediately.
• Select the Auto-refresh check box to enable an automatic refresh of the page at
regular intervals.