62 Installation Guide
on the RJ45 plug. Feed the network cable ⑦ through the
screw cap ⑥, rubber gasket ⑤ (the flat portion of the
rubber gasket goes towards the screw cap), and the
protective connector sleeve ④ in the order shown in
Figure 8.
2. Crimp an RJ-45 network plug ③onto the end of the cable,
ensuring that the twisted pairs of wires are in the correct
order.
3. Place the rubber washer ② onto the mating end of the
RJ45 connector on cable harness ①.
4. Insert the RJ45 network plug ③ into the RJ45 connector
①.
5. Slide the rubber gasket ⑤ into the protective cover
sleeve ④, and secure/tighten the screw cap ⑥ onto the
protective connector sleeve ④.
6. Align the snap ridges inside protective cover sleeve④
with the ridges inside of the RJ45 connector ①. Rotate
the protective cover sleeve to tighten up against the RJ45
connector ①, as shown below.
To Next Page
Loading...
