Chapter 13: Alarm and event setup
TruVision DVR 15HD User Manual 107
2. Under Select Intrusion Panel, select intrusion panel 1, 2 or 3.
3. Select the desired ID of a zone. The maximum is 32. The number does not have to
match the zone number.
4. Under Zone Number, select the desired zone number. The zone number can be
any valid number of the panel, which does not need to match the zone number.
5. Click Action to define the actions for the selected zone number.
Trigger Channel: Select the cameras that will record when an alarm event is received.
The cameras will record following the main stream (alarm) parameters.
The recordings will be 10 seconds for each assigned camera.
Arming Schedule: Define the alarm schedule for the actions. You can schedule up to
eight periods in a day. Default is 24 hours.
Actions: Check the required action that needs to be executed when an alarm is
received:
Enable an alarm audio (buzzer)
Notify the alarm host (supported by TruVision Navigator 7.0)
Send email
Trigger an alarm output
PTZ Linking: Select the PTZ camera as well as the preset, preset tour, and/or
shadow tour that is triggered when the alarm/event is detected.
Click Apply to save the settings. Click OK to return to the main window.
6. Click Apply to save the intrusion panel setup parameters.
7. Click Exit to return to live view.
To Next Page
Loading...
