xGenConnect Installation and Programming Guide 137
Then we click to Event List 2 and enter the name “Informational”. Tick Opening
and Closing, and Autotest Report.
Programming Instructions for Channels
Goal
Set up communication paths and destinations for delivering event messages.
Pre-conditions
Communicator must be programmed (see “Programming Instructions for
Communicator” on page 130).
Event Lists must be programmed (see “Programming Instructions for Event Lists”
on page 135).
Notes
• Area Account Number will take priority over Account Number entered here for
Zone events. If no Area Account Number is entered then this number will be
used instead.
• Next Channel must be a higher value than the current Channel Number.
Circular loops are not permitted.
• Take note of the Sequence Attempts under Communicator > System Event
Reporting (6.11.2). This is the number of times xGenConnect will attempt the
sequence of Channels you set up in this section.
• Channel set up for push notifications is automatically performed by the
UltraSync+ app when required. The panel will assign the next available
channel and matching event list number. No configuration via the web pages
or DLX900 is required.
Event
System / Area
Channel Group 1
Channel Group 1
Channel 1
Channel 4
Channel 6
Menu 6.11.1.1 or 4
Event sent to
Channel Group
Menu 18 – Channel Groups
Menu 5 – Channels Menu 17 – Event Lists
Each channel checks to
see if the event is on its
Event List, if yes it will
attempt to send, if not
then it stops.
Channel Group sends event
to Channel it containsevery
Channel 1
Control Room 1
Channel 4
Control Room 2
Channel 6
Email
Event List 1
Critical
Event List 2
Informational
Event List = 1
Event List = 1
Event List = 2
Alarms
Bypass & Restore
AC Fail
Open & Closes
Autotest
To Next Page
Loading...
Need help?
General
