34 xGenConnect Installation and Programming Guide
Arm Your System in Stay Mode
Enter a valid PIN code to unlock the screen. Press the Arm Stay button to arm
the system in Stay mode.
Using Up (2) and Down (8) buttons, select one of the following Stay Arming
modes:
• Stay
• Stay Instant
• Stay Instant Night
Next, press Enter, enter your PIN, and then press Enter again.
Note: In case the Quick Arm function is enabled, a PIN is not required to arm the
system in Stay mode.
If your system has multi-partition control enabled, and the user has the Display
Partition List option enabled, the Partition selection screen will be displayed.
Disarm Partitions with NXG-1820-EUR keypad
Touch the Off or Off + button to disarm your system:
If your system has multi-Partition control enabled, the Off + button will be
displayed.
A valid PIN code will need to be entered to determine what permissions they
have, this includes which Partitions and at what time/day that user has access.
Disarm Partitions with NXG-183x-EUR keypad
Enter a valid PIN code to unlock the screen.
Typically, the buzzer will sound (continuous tone) announcing the entry delay.
Press the Disarm button followed by a valid PIN code to disarm your system.
If your system has multi-partition control enabled, and the user has the Display
Partition List option enabled, the Partition selection screen will be displayed.
A valid PIN code will need to be entered to determine what permissions they
have, this includes which partitions and at what time/day that user has access.
Activate SOS Feature (NXG-1820-EUR only)
Touch the SOS button to display the SOS feature:
To Next Page
Loading...
Need help?
General
