56 xGenConnect Installation and Programming Guide
- Custom users can have additional permissions and settings configured.
9. Click Save.
Adding a Keyfob
1. Log in to the Web Server.
2. Click Settings.
3. Click Keyfobs.
4. Use the drop-down menu to select the keyfob number you want to add to the
system.
5. Click Learn.
6. Trigger the keyfob learning function for 2 seconds (on 63-bit keyfobs hold
down the arm and disarm buttons, on 80plus keyfobs hold down the Arm +
2 buttons). The screen will show the keyfob has been found and the Serial
Number will appear.
The keyfob will have access to Area 1 and the panel will report the keyfob
number to the Central Monitoring Station when it is used.
7. Click Save.
Advanced Keyfob Programming
Three levels of access are possible:
1. Area 1 only: This is the default behaviour after learning a keyfob. The User is
set to “Use FOB Number as Standard User”.
2. All partitions: Click the drop-down User menu to assign the keyfob a User
number. The keyfob will inherit partitions and permissions of that user. New
users and the default Master and Standard user accounts have access to ALL
To Next Page
Loading...
Need help?
General
