152 xGenConnect Installation and Programming Guide
5. Trigger each sensor by walking past PIRs, opening and closing reed
switches, pressing tamper buttons, etc. Siren will chirp multiple times for each
zone triggered.
6. Click Stop.
7. Click History.
User Reporting
When enabled, quick arming/disarming from the keypad without a PIN code will
report user 999 to the Central Monitoring Station. SOS functions also report as
user 999.
If the installer PIN is used to arm/disarm, user 256 is reported to the Central
Monitoring Station. On legacy NX keypads user 255 will appear in event history.
To Next Page
Loading...
