Interlogix xGenConnect NXG-4 - Page 156

144 xGenConnect Installation and Programming Guide
• Take note of the Sequence Attempts under Communicator > System Event
Reporting (6.11.2). This is the number of times xGenConnect will attempt the
sequence of Channels you set up in this section.
Programming Sequence
17. Event Lists
→
5. Channels
→
18. Channel Groups
→
6. Communicator
17. Event Lists
6. Communicator
a) Options
b) IP Config
c) Ethernet
d) Radio
e) Dial IP
f) Email
g) Remote Access
h) System Event
Reporting
18. Channel Groups
Instructions
1. Go to Communicator, System Event Reporting.
2. Select a Channel Group.
Done. The xGenConnect will now report system events to the Channels selected
in the Channel Group you just selected.