Interlogix ZEROWIRE ZW-6404 - Installing Cellular Radio; Connecting Power

20
Installing Cellular Radio
1. A mobile phone can provide general guidance on mobile network coverage. Look at the
signal level on a mobile phone to verify there are 4/5 to 5/5 bars of reception in the
location where you will install the ZeroWire.
1 bar
2 bars
3 bars
4 bars
5 bars
Low
OK
If the signal strength is low, find another location which has stronger signal levels.
Note that actual signal level can only be determined using the ZeroWire connected to a
specific network, which may be different than your phone.
2. If a cellular radio module is pre-installed, skip to the Check Signal Level section. If not,
remove the cover on the right.
3. Locate the 10-pin lead inside the ZeroWire and connect this to the radio module.
Connecting Power
1
. Connect a DC power lead from power pack to the back of the ZeroWire, it only fits
when inserted in the correct direction.