Interlogix ZEROWIRE ZW-6404 - Installing The Battery; Installing ZeroWire on Wall

24
Installing The Battery
1.
Remove battery cover
with a small screwdriver.
2. Connect battery pack lead
to connector on left.
3. Replace battery cover and
screw.
Note: The battery wire cannot be under the battery or the cover will not fit properly.
Note: The battery is not designed as a long-term power source. Plugging in the battery
should be followed quickly with the plugging in of the DC power supply.
Installing ZeroWire on Wall
1. Install the bracket on a wall by using the supplied screws. Make sure the power lead
can reach the ZeroWire when plugged in to a power source.
2. Align the ZeroWire to the top clips on the wall bracket, then slide the ZeroWire in to
place so it sits flat against the wall.
3. Use a screw driver to tighten the screw you loosened previously