Interlogix ZEROWIRE ZW-6404 - Event History; Reviewing System Events

72
Example: Perform a communicator test
1.
Call your central monitoring station and
tell them you are performing a
communicator test.
2.
Select main menu - Option 4, System Test.
3.
4.
Select communicator test.
5.
The central monitoring station will
confirm the test message was received.
6.
Exit from the menu.
7.
If the communicator test fails, notify your
service provider.
Event History
The Event History menu is used to listen to events that occurred in your security system.
These events include arming, disarming, system faults and alarmed zones. Ensure your
clock is set correctly as all events are time stamped.
“Alarm Memory” will announce the last zone(s) that caused your security system to go into
an alarm condition:
1.
HISTORY
Select History Menu.
2.
3.
Listen to the last alarm memory event.
4.
Exit from History Menu.
It is recommended you record user names, zone names, and outputs names in Menu 8 –
Recordings. This will make reviewing any events much clearer as ZeroWire will announce
the recorded name.
MENU
1
ENTER
YOUR 4 TO 8 DIGIT MASTER CODE
MENU
MENU
MENU
2
ENTER
YOUR 4 TO 8 DIGIT INSTALLER CODE
4
MENU