Interlogix ZEROWIRE ZW-6404 - Installing ZeroWire on Desk; Resetting to Factory Defaults

ZeroWire Installation Manual 25
4. If required, the box tamper feature can be enabled from the System Menu – General
Options via the ZeroWire Web Server. This will cause an alarm to occur if the ZeroWire
is removed from the wall.
Installing ZeroWire on Desk
If you do not wish to install the product on a wall, you may use the optional ZW-DS01 table
stand to place the ZeroWire on a secure flat surface. Cables should route through the hole
in the base. Ensure the box tamper is off.
Resetting to Factory Defaults (optional)
Follow these steps to reset your ZeroWire back to factory default settings:
1.
Select main menu - Option 9.
2.
Enter your Installer code.
3.
Select resetting to the factory defaults.
4.
Confirm by pressing the BYPASS key, and then wait
10 seconds.
5.
Exit from the menu.
MENU
MENU
MENU
BYPASS
0
ENTER
YOUR 4 TO 8 DIGIT INSTALLER CODE
9
MENU