Interlogix ZEROWIRE ZW-6404 - Recording Zone Names; Testing Zone Signal Level

52
Recording Zone Names (optional)
You can also record the names of the first 64 zones using your voice.
Example: Record user name for zone 1
1.
Select main menu - Option 6, Basic system
configuration.
2.
Enter your Installer code.
3.
Select zone name recording.
4.
Select zone 1.
5.
Activate recording mode.
6.
Record voice, maximum 2 seconds.
7.
Stop recording mode.
8.
Exit from the menu.
Testing Zone Signal Level
Check the signal level of each zone once installed.
1.
Select Main Menu - Option 4 – System Test
2.
Enter your Installer code.
3.
Select zone walk test
6.
Trip each zone and listen to the voice feedback on the
panel.
8.
Exit from the menu.
If signal is low, then move zone to another location. Alternatively move your ZeroWire to a
more central location.
MENU
MENU
MENU
TRIP DETECTOR
4
ENTER
YOUR 4 TO 8 DIGIT INSTALLER CODE
4
MENU
MENU
MENU
MENU
RELEASE HISTORY
( ( SPEAK NAME ) )
HOLD DOWN HISTORY KEY
ENTER
1
4
ENTER
YOUR 4 TO 8 DIGIT INSTALLER CODE
6
MENU