ZeroWire Installation Manual 63
3. Follow instructions on web page:
4. ZeroWire will pulse the on board siren each time a sensor is triggered, no alarms will
be reported during Walk Test.
5. Click End Walk Test when finished and check signal levels:
6. If signal is low, move the detector to another location. Alternatively move your ZeroWire
to a more central location if multiple zones have poor signal levels.
Adding a User/Keyfob
ZeroWire allows you to add up to 40 users. Each user is assigned a PIN code and a user
number. This allows them to interact with the system.
1. Connect to the ZeroWire Web Server (either via WiFi Discovery Mode, WiFi LAN,
Ethernet LAN, or the UltraSync + app).
To Next Page
Loading...
