Intermec CK61 - Autocopy

Chapter 3 — Configuring the Computer
CK61 Mobile Computer with Windows Mobile User’s Manual 87
AutoRun handles quoted file names for the first parameter which allows
you to specify path names or file names that contain white space. Note that
only one set of quotes per command is supported.
AutoRun.dat entry examples:
AutoCopy
AutoCopy (AutoCopy.exe) copies or moves files from one location to
another. It has no user interface and is configured through command line
arguments. It has support for the following parameters:
Usage:
AutoCopy [-D["W"]] [-L["X"]] [-M[D]] [-Q[Y]] [-S["Z"]]
The return code from the process uses the standard error codes defined in
WinError.h.
Example:
Use AutoCopy to copy the Audio control panel from Flash File Store to the
Windows directory.
autocopy.exe -S"\Flash File Store\System\Audio.cpl" -D"\Windows\Audio.cpl
Use AutoCopy to move the Audio control panel from Flash File Store to the
Windows directory.
autocopy.exe -M1 -S"\Flash File Store\System\Audio.cpl" -D"\Windows\Audio.cpl"
EXEC Launches a specified program, waits for it to complete (up to 10 minutes).
CALL Processes a specified file of commands and returns.
CHAIN Processes a specified file of commands and does not return.
RUN Loads a specified program and executes it.
LOAD Loads a specified program and executes it.
RUN “Flash File Store\Apps\some.exe” arg1, arg2, arg3
CALL “Flash File Store\2577\usercmds.dat”
-D Indicates the destination file name and must be fully qualified. W is a string
value.
-L Indicates a fully qualified file name for logging to enable. Default is disabled. X
is a string value.
-M Moves file to a destination rather than copies the file. Default value is disabled.
D is an integer value. D=1 indicates enabled, 0 is disabled.
-Q Indicates if a message box should appear when an error occurs. Default is
disabled. Y is an integer value.
-S Indicates a source file name and must be fully qualified. Z is a string value.