Intermec CK61 - Using the Smartsystems Console to Upgrade the Computer; Maintaining the Computer

Chapter 4 — Maintaining the Computer
CK61 Mobile Computer with Windows Mobile User’s Manual 105
1 Extract the upgrade files to a Secure Digital card.
2 Using a stylus, press the Reset button inside the battery cavity, press and
hold the power switch until the clean boot menu appears, then press
Enter to reflash the PSM/IVA.
3 The operating system will boot and load files from the Secure Digital
card. The process is complete once the pen calibration screen is visible.
After this, remove the files from the Secure Digital card.
When the CK61 finishes booting, you may use it. You have reset the CK61
to its default configuration. You need to set the date and time and to set its
network communications parameters to reestablish communications with
the other devices in the wireless network.
Using the SmartSystems Console to Upgrade the Computer
Use the SmartSystems Console to upgrade the operating system on your
CK61. The console is part of SmartSystems Foundation and is available
from the Intermec web site via the IDL. Before you can upgrade your
computer, you need:
• the SmartSystems Foundation. To download SmartSystems Foundation,
go to www.intermec.com/idl and open the Device Management page.
• the device upgrade .exe file, which is available from the Intermec web
site at www.intermec.com. Go to Service & Support > Downloads.
1 Install SmartSystems Foundation on your desktop or laptop computer,
then open the console.
2 Make sure the console and the CK61s are on the same subnet. For help,
contact your Intermec representative.
3 Make sure your CK61s are either in a communications dock or charging
dock, or that power management is disabled.
4 Download the device upgrade .exe file to your desktop or laptop
computer.
5 Double-click the .exe file on your desktop or laptop computer. An
InstallShield application starts and walks you through the process of
extracting the upgrade files in the default location.
6 From the SmartSystems Console, locate the device upgrade to install.
7 Drag-and-drop the device upgrade onto each CK61 icon.
Once the upgrade is done downloading to your CK61, your CK61 replaces
the operating system, then automatically performs a cold boot.
Note: Do not change the default location where InstallShield extracts the
files. The SmartSystems Console requires the files be in this location.
The SmartSystems Console shows your CK61 as offline (via a red stop sign)
until the device reboots and reconnects to the system.