Chapter 3 — Configuring the Computer
CK61 Mobile Computer with Windows Mobile User’s Manual 91
To access the Intermec Settings applet
For detailed information on most of the commands available in the
Intermec Settings applet, see the Intermec Computer Command Reference
Manual (P/N 073529).
Synchronizing the Computer System Time with a Time Server
It is important that the time on all of your CK61s be synchronized with a
network time server to ensure real-time communications and updates.
Network time servers acquire Coordinated Universal Time (UTC) from an
outside source such as the U.S. Naval Observatory (USNO). The CK61
uses Simple Network Time Protocol (SNTP) to synchronize with a network
time server.
The default reference time server is the USNO (tock.usno.navy.mil). To
synchronize the time on your CK61 with this time server, you must have a
valid connection to the Internet. You can also synchronize the CK61 system
time with a corporate network server within your firewall that is SNTP-
capable. To use an internal corporate network server, you need to set the
command name in the registry.
Configuring the Computer through the Network
You can change the configuration parameters of the CK61 by sending
commands through a host computer or through the network. If you are
using a network, you can configure one or more CK61s at a time. You can
remotely configure the wireless or Ethernet CK61 by sending a command
from an application on the host computer.
• From the CK61 desktop, select Start > Settings > the System tab > the
Intermec Settings icon.
Note: You cannot set all parameters through the network. You can only set
those commands that have a syntax in the Intermec Computer Command
Reference Manual.
To Next Page
Loading...
