Intermec CK61 - Configuring the Computer in a UDP Plus Network

Chapter 3 — Configuring the Computer
CK61 Mobile Computer with Windows Mobile User’s Manual 93
The CK61 returns the CgS+BV4 transaction to the host application, where:
Configuring the Computer in a UDP Plus Network
You can use the host computer to configure a CK61 in your wireless or
Ethernet network. To send and receive configuration data or files, you need
to write a host application that can communicate with an Intermec
Application Server (formerly Gateway or DCS 30X).
For help, see the appropriate Gateway or DCS 30X User’s Manual. Use the
Terminal Message Format (TMF) protocol to send and receive transactions
between the host application and the CK61.
To set up the Intermec Application Server
• Configure a peer-to-peer destination name for the host application.
Create a transaction ID, $NGCFGRSP, that routes to this destination
name. The Intermec Application Server uses the transaction ID to route
responses from the CK61 back to the host application. $NGCFGRSP is
a special transaction ID that the server uses to forward configuration
response data from CK61s.
All configuration responses are routed with the $NGCFGRSP transaction
ID. The Intermec Application Server cannot track multiple applications
sending reader or configuration commands. If you have two host
applications sending reader or configuration commands, they must both be
configured to receive the $NGCFGRSP transactions, and therefore both
receive all responses from all CK61s.
To set up the host computer, verify that the host computer can
communicate with the Intermec Application Server.
To set up the application, prepare and write a host application that can
communicate with the Intermec Application Server and send transactions
to and receive transactions from the CK61 in this format. For an example
of the host application transaction, see the previous section..
Cg is a TMF Configuration Get response.
$+ is the Change Configuration reader command.
BV4 means the Beeper Volume configuration command is currently set to a
value of 4, which is a very high beeper volume.
transaction header TMF field commands