Chapter 5 — Network Support
158 CK61 Mobile Computer with Windows Mobile User’s Manual
To obtain a user certificate from an IAS server
•Tap Web Enrollment to obtain a user certificate over the network from
an IAS Server. Tap ok to return to the Security page.
Using LEAP (Cisco Lightweight EAP)
LEAP is the Cisco Lightweight version of EAP.
Use “LEAP” to configure the use of LEAP as an authentication protocol,
select “Open,” “WPA,” “WPA2,” or “Network EAP” as an association
mode, or assign “Network EAP.”
To configure using LEAP
1 Set 8021x Security as “LEAP,” then choose one of the following:
•Set Association to “Open.”
•Set Association to “WPA.”
•Set Association to “WPA2” and Encryption to “TKIP” or “AES.”
•Set Association to “Network EAP” and Encryption to either
“WEP” or “CKIP.” (default configuration)
2 Enter your unique Username to use this protocol.
To Next Page
Loading...
