Chapter 5 — Network Support
CK61 Mobile Computer with Windows Mobile User’s Manual 139
8 Insert necessary equipment, such as a network (Ethernet) card, into the
CK61, and use a desired program to begin connecting.
Ending a Connection
• When connected via cable or cradle, detach your CK61.
• When connected via Infrared, move the CK61 away from the other
computer or device.
• When connected via a wireless network, switch off the connection.
iConnect
The default network adapter or radio is dependent on what radios are
installed in your CK61. With the iConnect menu, using the Enable
feature, you can specify “802.11b,” “Ethernet,” or “No Networking” to load
onto your CK61 when a cold boot is performed.
If you had specified a network prior to when a warm boot is performed on
the CK61, the iConnect application restores your network interfaces to
what they were before the warm boot was performed.
See the Developer’s Support area of the Intermec web site for the latest
information on network adapters for your unit.
• Select Dismiss from the iConnect menu to end the session without
exiting the application.
• When connected via modem or VPN, tap the Connectivity icon on the
top, then tap Disconnect.
To access the iConnect menu, tap the iConnect icon above your command
bar for the following menu:
To Next Page
Loading...
