Chapter 5 — Network Support
CK61 Mobile Computer with Windows Mobile User’s Manual 151
To disable 802.1x security and enable WEP encryption
•Set 8021x Security as “None,” Association to “Open,” and Encryption
to “None.”
To enable WEP encryption
1 Set 8021x Security as “None” and Association to “Open” or “Shared”
as required to match the settings in your access point.
2 Set Encryption to “WEP.”
3 Select a data transmission key from the Data TX Key drop-down list
near the bottom of this screen.
4 Enter an ASCII key or a hex key either 5 or 13 bytes long based on the
radio capability in the appropriate Key # field. Set a 5-byte value for 64-
bit WEP or a 13-byte value for 128-bit WEP. Precede hex keys with 0x
and make sure the keys use 5 or 13 hex pairs.
To enable WPA encryption using a pre-shared key
1 Set 8021x Security as “None.”
2 Set Association to “WPA.”
Note: “Open” is the recommended choice as the “Shared” key
authentication has security weaknesses.
To Next Page
Loading...
