Chapter 5 — Network Support
CK61 Mobile Computer with Windows Mobile User’s Manual 153
To configure using PEAP
1 Set 8021x Security as “PEAP,” then choose any of the following:
•Set Association to “Open.”
•Set Association to “WPA.”
•Set Association to “WPA2” and Encryption to “TKIP” or “AES.”
•Set Association to “Network EAP” and Encryption to either
“WEP” or “CKIP.”
2 Enter your unique Username and password to use this protocol.
3 Select Prompt for password to have the user enter this password each
time to access the protocol; or leave Use following password as selected
and enter your unique password to use the protocol without entering a
password each time you use your CK61.
4 Tap Get Certificates to obtain or import server certificates (page 157).
5 Tap Additional Settings to assign an inner PEAP authentication and set
options for server certificate validation and trust.
Additional PEAP Settings
To configure additional PEAP settings
1 Select a method from the Inner PEAP Authentication drop-down list.
2 Check Validate Server Certificate to verify the identity of the
authentication server based on its certificate when using PEAP.
Method Definition
EAP/MS-CHAP-V2 Authenticates against a Windows Domain Controller and other
non-Windows user databases. This is Microsoft's
implementation of PEAP.
EAP/Token Card Use with token cards. The password value entered is never
cached. This is Cisco's implementation of PEAP.
EAP/MD5-Challenge Message Digest 5. A secure hashing authentication algorithm.
To Next Page
Loading...
