Chapter 1 — Using the Computer
CK61 Mobile Computer with Windows Mobile User’s Manual 11
4 When the CK61 successfully reads a bar code label, you hear a high
beep and the green Good Read light turns on briefly.
5 Release the Scan button or the trigger.
If there are multiple bar codes in one area, you should enable the center-
decoding option to read your bar codes. The center-decoding option
only decodes a bar code if:
• the laser pointer is on the bar code.
• the illumination beam covers the bar code.
Before you can use the center-decoding option you must enable it using
Intermec settings.
To select the center-decoding option
•Tap Start >Settings > System >Intermec Settings > Data Collection
> Decode Security > Center Decoding.
To scan a bar code using center-decoding
1 Press the power switch to turn on the CK61.
2 Point the scanner window at the bar code label and hold the CK61
steady and pointed at the label.
3 Press the Scan button on the keypad or pull the trigger on the handle.
The illumination beam and the laser pointer appear.
4 Aim both the illumination beam and the laser pointer at the bar code
you want to scan.
5 When the CK61 successfully reads a bar code label, you hear a high
beep and the green Good Read light turns on briefly.
6 Release the Scan button or the trigger.
If you have problems scanning a bar code with the area imager, try
following some of these tips to improve the performance of your imager:
• Keep your hand as steady as possible while scanning a label.
• Make sure that Aimer LED Duration is set to zero.
• Position the imager as close to the bar code as possible while still being
able to capture the entire bar code.
• Enable only the bar codes that you need to use every day.
Note: Use the same steps to disable the center-decoding option.
To Next Page
Loading...
