Intermec CK71 Series - Page 24

TITLE
Model
DOCUMENT NO.
PAGE
CK71 Service Work Instructions
CK71A
SWICK71-000
Page 24 of 42
Removal
1. Remove the bottom housing assembly (refer to Bottom Housing operation).
2. Remove the core assembly from the top housing (refer to Core Assembly operation).
3. Using a #1 Phillips screwdriver remove two screws (one on each side) that attach the display assembly to the core
assembly.
4. Carefully lift the display assembly away from the core assembly and disconnect the LCD flex cable and touch
panel flex cable from the main logic board. Be careful with flex connectors on the main logic board as they are very
fragile.
Installation
LCD flex
cable
Touch panel flex
cable
1
2
3