Chapter 5 — Troubleshooting and Maintaining the CV30
90 CV30 Fixed Mount Computer With Windows CE User’s Manual
To clean boot the CV30
1 Press the Power button to turn off the CV30 and hold.
2 Using a small pointed device (such as the end of the stylus) or
your finger, press the Reset switch on the top of the CV30.
The blue light on the CV30 blinks once and the CV30 starts
the booting sequence.
3 Release the Power button when a Warning message appears
on the display asking if you want to clean boot the system.
4 Press the Volume Up button to start the clean boot process.
After some programs load, you are prompted to calibrate the
screen.
5 Calibrate the screen and then tap anywhere on the screen to
exit the application. The CV30 continues with the boot
process.
6 Reload any custom applications that may have been erased
during the clean boot and reset the time and date.
To preserve application programs through a clean boot, you
must store them in the Flash File Store.
Do not use force or a sharp object when pressing the reset
switch. You may damage the reset switch.
802.11
Reset
To Next Page
Loading...
Need help?
General
