Chapter 3 — Configuring the CV30
CV30 Fixed Mount Computer With Windows CE User’s Manual 31
Use this table to understand the settings you see in the Bluetooth
menu in Intermec Settings.
Configuring the CV30 to Communicate With a Wireless Scanner
This section explains how to configure the CV30 to
communicate with Bluetooth wireless scanners. The CV30 ships
with a Bluetooth association label attached to the left side. Scan
the association label to quickly connect the CV30 to the
Bluetooth wireless scanner.
If for some reason the Bluetooth association label does not work,
you can follow the procedure for configuring the CV30 from
Intermec Settings at the end of this section.
To configure Bluetooth communications on the CV30
1 Select Start > Settings >Control Panel > Intermec Settings.
2 Select Communications > Bluetooth.
3 If you want to allow incoming connections from wireless
scanners, you must enable these two parameters:
•Discoverable
• Connectable
Bluetooth Settings
Setting Description
Power Set and view whether the Bluetooth radio is on or
off.
Discoverable Allows other Bluetooth devices to be able to
discover the CV30 during a device discovery.
Connectable Allows other Bluetooth devices to connect to your
CV30.
Class of Device Determines how the device appears to other devices
during discovery.
IBT Displays the version of the Intermec Bluetooth
Library.
Radio Displays the version of the Bluetooth Radio
Hardware.
Device Address Displays the Bluetooth address of your CV30.
To Next Page
Loading...
Need help?
General
