Intermec EasyCoder F2 – Installation & Operation Ed. 2 41
Chapter 6 Setting Up the Printer
Default Setup
The printer is by default set up according to the list below:
Ser-Com "uart1:"
Baudrate: 9600 bps
Character length: 8 bits
Parity: None
Stop bits: 1 bit
RTS/CTS: Disable
ENQ/ACK: Disable
XON/XOFF, data to host: Disable
XON/XOFF, data from host: Disable
New line: CR/LF
Receive buffer: 300 bytes
Transmit buffer: 300 bytes
Feedadjust:
Startadjust: 0
Stopadjust: 0
Media:
X-start: 24
Width: 424
Length: 1200
Media Type: Label (w Gaps)
Label Constant: 85
Label Factor: 40
Contrast: ±0%
Print Defi nes:
Print speed: 100 mm/sec.
The printer's current setup values can be read from the display by
browsing through the Setup Mode, or from the host by browsing
through the Terminal Setup of Intermec Shell.
You can list the printer's current setup values by printing test label
#5 in the Setup Mode or using Intermec Shell.
The current setup values can be returned to the host by means of a
SETUP WRITE "uart1:" statement (see Intermec Fingerprint
7.xx Reference Manual).
To Next Page
Loading...
Need help?
General
