Intermec easycoder f2 Installation & Operation Manual

Intermec EasyCoder F2 – Installation & Operation Ed. 254
Chapter 7 Setup Mode
Navigating in
Setup Mode
While going through the setup procedure, you are guided by texts in
the printer's display. You can step between setup menus, acknowledge
displayed values, select or type new values etc. by means of some of
the keys on the printer's keyboard.
Note!
An external keyboard cannot be used inside the Setup Mode.
1
/. “Left”, “right”, “up”, and “down” refer to the diagrams on
the following pages.
Move up one level or scroll back in a stack
of options
1
.
Move one menu to the right on the same
level
1
.
Move one menu to the left on the same
level
1
.
Specify negative values (leading position)
Enter numeric values.
Exit the Setup Mode.
(Can be used anywhere in the Setup Mode).
Clear erroneously entered values.
Acknowledge and move to next menu.
Perform testfeeds in the Testfeed menu.
Print test labels in the Test Label menu.
Move down one level or scroll forward in a
stack of options
1
.
Display error message at test labels printing
failure.
-

Intermec easycoder f2 Specifications

General

Brand	Intermec
Model	easycoder f2
Category	Barcode Reader
Language	English