Intermec EasyCoder F2 – Installation & Operation Ed. 28
Chapter 1 Introduction
Safety
Requirements
Product Labelling
Intermec assumes no responsibility as regards fulfi lling the CE
Directive if the printer is handled, modifi ed or installed in any way
other than that described in Intermec's manuals.
Caution
• Read this manual carefully before connecting the printer.
• Moving parts are exposed when the side door is open, so ensure
that the door is closed before you operate the printer.
• Do not open the front/left-hand cover. Dangerous voltage!
• Do not remove the bottom plate. Dangerous voltage!
• Do not put your fi ngers inside the print mechanism when
the power is on.
• Place the printer on an even surface which can support its weight
of approximately 5.5 kgs (12 lbs) plus supplies.
• Do not spray the printer with water. If using a hose to clean the
premises in an industrial environment, remove the printer or
protect it carefully from spray and moisture.
• Carefully read the warning text on the envelope before using
a cleaning card.
The machine sign is attached to the printer's rear plate and contains
information on type, model and serial number as well as mains
voltage. It also contains various signs of approval.
To Next Page
Loading...
Need help?
General
