Chapter 4 — Troubleshooting and Maintaining the Printer
PD41 and PD42 Commercial Printer User’s Manual 87
3 Make sure that there is a label, not a gap or black mark, at the
sensor.
4 Make sure that the media runs as close to the center of the printer
as the guides will allow.
5 Press Setup ().
6 Go to Print Defs > LSS Test > LSS Auto. The cursor will in the
center of the screen as shown below.
7 For gap or slot detection: Lift the printhead and slowly pull out
the media in the media feed direction. When the label stop sensor
detects a gap or a detection slot, the cursor moves to the right.
8 For black mark detection: Lift the printhead and slowly pull out
the media in the feed direction. When the label stop sensor detects
a black mark, the cursor moves to the left.
If the cursor behaves as described in Steps 7 and 8, the label stop
sensor is working and is properly aligned.
To Next Page
Loading...
