Intermec PD41

Chapter 2 — Connecting the Printer
PD41 and PD42 Commercial Printer User’s Manual 29
<STX><SI>wt,WEP1<ETX>
<STX><SI>wt,PAC<ETX>
<STX><SI>wt,ACQUIRE_PAC<ETX>
<STX><SI>wt,WEP2<ETX>
<STX><SI>wt,WEP3<ETX>
<STX><SI>wt,WEP4<ETX>
<STX><SI>wt,AUTH<ETX>
<STX><SI>wt,WPA<ETX>
<STX><SI>wt,WPA2<ETX>
<STX><SI>wt,WPA_PSK<ETX>
<STX><SI>wt,ROAM<ETX>
<STX><SI>wt,CHANNEL<ETX>
<STX><SI>wt,AP_MAC<ETX>
<STX><SI>wt,SIGNAL<ETX>
<STX><SI>wt,SPEED<ETX>
<STX><SI>wt,ACTIVE<ETX>
If you are using Fingerprint, send this command to the printer:
setup write "wlan","uart1:"
setup write "8021x","uart1:"
4 Set up the printer to use the correct SSID and authentication
modes. For help, see the next section, Configuring 802.11
Wireless Security Using IPL or “Configuring 802.11 Wireless
Security Using Fingerprint” on page 32.
5 If you are going to use certificates for validation, transfer the
certificate to the printer. The printer can accept .pfx, .pem, and
.der certificates.
6 Verify that the printer is connected to the access point and make
sure it has an IP address allocated to it.
Use the following sections to set most of your wireless
communication settings. For help with additional commands and
information, see either the Intermec Fingerprint Command Reference
Manual or the IPL Command Reference Manual. You can download
both documents from the Intermec web site at www.intermec.com.
Configuring 802.11 Wireless Security Using IPL
Use the following procedures to configure 802.11 wireless security
parameters on your printer using IPL.