Intermec PD41

Chapter 2 — Connecting the Printer
PD41 and PD42 Commercial Printer User’s Manual 27
3 Disconnect the printer from the PC.
4 On your PC, enter the IP address of the printer in the address field
of your web browser (for example http://10.200.27.94) and press
Enter.
The home page of the printer appears.
Setting Up 802.11 Radio Communications
The printer can have an internal 802.11 b/g radio to transfer and
receive data using wireless communications. This user’s guide
assumes that you have already set up your wireless communications
network including your access points. The following procedures
include information on setting up wireless security for both IPL and
Fingerprint.
The printer supports these authentication modes: none, WEP, WPA
Personal and Enterprise mode (802.1x authentication), WPA2
Personal and Enterprise mode (802.1x authentication).
To set up the printer to work in your wireless network, you need these
items:
• Serial cable (P/N 1-974024-018)
• Host PC running Windows or Linux
• PrintSet. You can download PrintSet from the Downloads page
for your printer on www.intermec.com or you can download it
from the PrinterCompanion CD that shipped with your printer.
• (optional) Serial port software such as HyperTerminal®
To set up the printer for wireless communications using PrintSet
1 Download and install PrintSet on your PC.
2 Connect one end of the serial cable to the back of the printer and
connect the other end of the cable to a serial COM port on the PC.
Note: WPA and WPA2 Enterprise mode and dynamic WEP currently
support PEAP, TTLS, LEAP, and EAP-Fast.