Chapter 3 — Configuring the Printer
PD41 and PD42 Commercial Printer User’s Manual 45
Use the following table to understand the Web Shell settings.
Configuring Alerts
Use the Alerts page to view and change the printer alert settings.
To configure alerts
1 Click Printer > Alerts.
2 Change the alert settings:
• Choose Enabled or Disabled from the Setting list.
• Specify a Delay repeat in the text field.
• Select seconds or occurrences in the Delay Unit list.
• Enter a message in the Message text field.
3 Select the Notification method.
Understanding the Web Shell Settings
Setting Description
Testfeed [value] Calibrates the label stop sensor performs a
testfeed. Selecting this setting is equivalent to
issuing the TESTFEED command on the
printer.
Ribbon Sensor Detects is the printer has run out of ribbon
during printing.
Default Setup Returns the printer to factory default settings.
Passwords, alerts, and the selected application
are not changed.
Reboot Reboots the printer.
Print Test Label Prints the predefined test label you choose.
Command Language Sets the command language to Fingerprint,
Direct Protocol, IPL, ESim, ZSim, or DSim. You
need to reboot the printer for the change to take
effect.
Fingerprint Application Defines the application to run as the default on
startup. You need to reboot the printer for the
change to take effect.
Standard I/O Defines the port the printer listens to. You need
to reboot the printer for the change to take
effect.
To Next Page
Loading...
Need help?
General
