Appendix B — Default Settings
110 PD41 and PD42 Commercial Printer User’s Manual
Default Configuration
Use this appendix to view the default settings on the printer. If you
need to restore factory defaults at any time, you can use PrintSet or
the printer home page to reset the printer.
To reset the printer to factory defaults using Printset
• Use the Factory Default Wizard in the Printer Tasks box.
To reset the printer to factory defaults using the home page
1 From the home page, click Printer > Web Shell.
2 Click Default Setup.
3 When prompted, click OK. The printer defaults are restored.
4 Reboot the printer.
The following tables list the default values of the configuration
commands supported on the PD41 and PD42 printers. If you restore
the printer to factory default settings, these are the values it uses.
The commands are grouped by function and reflect the organization
of the IPL and Fingerprint setup menus. For detailed information on
most of the commands, see the Intermec Fingerprint Command
Reference Manual or the IPL Command Reference Manual.
IPL Default Configuration
Ser-Com Parameters
Parameter Default Value
Baud rate 9600
Data bits 8
Parity None
Stop bits 1
Protocol XON/XOFF
To Next Page
Loading...
Need help?
General
